• Dongguan instrument welcome you, we will be good quality, bold innovation, welcome new and old customers to visit and guidance, we will sincerely service for you!
86-135 3248 7540
DongGuan ZhongLi Instrument Technology Co., Ltd.


》》Home > Products > Office furniture series testin > Office furniture series testin

ZL-3421 Automatic Reel Endurance Tester
  • 【Product name】:ZL-3421 Automatic Reel Endurance Tester
  • 【Specifications】:ZL-3421
  • 【Range of use】:It is a special testing equipment for testing whether the structure of automatic winding machine for household and similar electrical appliances has excessive scratch or damage of flexible flexible wire sheath, broken wire and excessive wear at contact.
  • 【Product Brief】:Automatic Reel Endurance Tester Product introduction: IEC60335 Household Appliances Automatic Reel Endurance Tester is designed and manufactured according to the requirements of GB4706.1 :22.16 and IEC60335-1:22.16. It is a special testing
Introduction

Automatic Reel Endurance Tester

 

 Product introduction:

IEC60335 Household Appliances Automatic Reel Endurance Tester

is designed and manufactured according to the requirements of GB4706.1 :22.16 and IEC60335-1:22.16. It is a special testing equipment for testing whether the structure of automatic winding machine for household and similar electrical appliances has excessive scratch or damage of flexible flexible wire sheath, broken wire and excessive wear at contact.It adopts multi-function fixture, oversize worktable, and can be used for the test of 300cm reel at maximum, with convenient and adjustable speed (5-30/MIN), strong universality, and suitable for the test of most electrical products.

 

 

Technical parameters:

 Power supply

 AC220V 50Hz;

 Working air source

 compressed air 5~7kg/cm2;(air source provided by customer)

 Test rate

 30 times /min (if the allowable rate of the reel structure is lower than 30 times /min, the test shall be conducted at the maximum allowable rate of the reel structure);

 Test times

 0~9999 times, automatically stop when the test reaches the specified number (adjustable);

 Driving mode

 pneumatic (compressed air) mode;

 Angle

 adjustable from 30 to 70°;

 Stretching stroke

 maximum 1000mm(adjustable).

 

Working principle:

Pull out two-thirds of the total length of the wire of the reel. If the length of the flexible wire that can be pulled out is less than 225cm, adjust the initial pull length of the flexible wire to make the reel still have 75cm of flexible wire.Pull out another section of cord 75cm long, then roll it back to the direction where the cord sheath will cause the maximum scratch, and pull the cord out taking into account the normal position of the appliance in use.At the point where the cord leaves the appliance, the included Angle between the cord axis during the test and the cord axis when it is rolled back without obvious resistance shall be approximately 60°.Soft wire is allowed to be rewound by a reel.Wind this piece of soft wire 6000 times at a rate of about 30 times per minute or the maximum rate allowed by the reel structure.